How to make the brim of a tree support larger?

[carlosgalvezp 0]

Hi,

 

I have a piece that needs supports. I am using tree supports because they are much easier to remove (at least on the PLA roll I use). The problem I have is that sometimes the trunk of the tree is too small, and I get adhesion issues, ultimately leading to the support snapping off the bed.

 

Question: how can I make the brim of the support larger, so that it does not get adhesion issues? I have tried the "Trunk diameter" and "Support Brim Width" options without effect, Cura silently caps it to a maximum.

 

Thanks!

Edited November 10, 2023 by carlosgalvezp

[Slashee_the_Cow 620]

Try changing "Initial Layer Diameter"

Edit: Needs to be used with "Trunk Diameter" because they won't reach the initial layer diameter if they're not trying to be that big to begin with.

Edited November 10, 2023 by Slashee_the_Cow