Ironing layer settings

[SensataPDS 2]

Hi, for the print settings i have and the varied models i print for fixturing, they may or may not have a nice flat top on them this means that when the top layer is of a small area the ironing setting will smudge fine details. can there be a option that allows the user to state a minimum ironing area rather than just on or off?

[Slashee_the_Cow 479]

I've found that ironing works fine even on small areas. There's no way to turn it off manually but you can create a support blocker, turn it into a cutting mesh and turn off ironing for that bit:

(I'm not sure if the forum will crush the image above so hard you can't see the difference so here's a close up)

 

I posted a slightly more comprehensive tutorial about how to make a support blocker and turn it into a cutting mesh here.