Oh, and welcome, Arjan!
Thanks, I tried to remove directly when the machine says it's ok, but think the bed is still around 40 degrees celcius then. Just tried waiting 15 minutes longer and that already helps ....
Welkom op het forum Arjan, welcome to the forum Arjan !
Recommended Posts
illuminarti 18
It's fine to put some pressure on the bed - I never take the glass off. Usually, once the plate has cooled to room temperature, prints will pop off quite easily with a little twist, or a sharp edge under a corner.
You don't want to try to remove the prints while the bed is still close to 60º, as you risk bending the plastic.
Link to post
Share on other sites