-
Our picks
-
UltiMaker Cura 5.8 Stable released 🎉
MariMakes posted a topic in UltiMaker Cura,
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!-
- 3 replies
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
Picked By
MariMakes, -
-
Recommended Posts
Slashee_the_Cow 410
It's always best to share the Cura project file (.3mf, get it set up then go to File > Save Project) so we can see all your settings.
I can see that the walls with differing flow rates have different Z seam locations. If your model is just a simple box like that it could be running afoul of Cooling > Minimum Layer Time and slowing down some layers to meet that time (which will reduce the flow rate because it'll be printing slower). Your best bet is to change the Z seam settings so that it's in a consistent location.
Link to post
Share on other sites