Jump to content
Ultimaker Community of 3D Printing Experts

Filament broke in feeder. Remove feeder or push new filament in?

Recommended Posts

While changing filament, it turns out the PLA broke around the hobbed bolt. The feeder reversed but the filament is still in the bowden tube from feeder to nozzle.

Do I remove feeder(cover) and pull out the filament? Or do I push new filament in and let it push through? (I'm thinking option 1 is a little more work, but a clogged nozzle due to option 2 is a lot more work...)


Share this post

Link to post
Share on other sites

I'd say it depends on the size of the broken filament.

It happens to me most of the time when i change filament, usually there's a little "blob" of filament that stays in the feeder. I was afraid first time but i tried to put in the new filament as if nothing was in the feeder. And the new filament simply pushed the blob all the way down to the extruder.

As a matter a fact i had this little blob for my first filament load (out of the box) and i had no problems


Share this post

Link to post
Share on other sites

I had the same situation. Except in my case I ran out of filament during a print, so a piece of filament got stuck all the way from the feeder to the nozzle. You can't have the feeder reverse the filament out because it is just past the feed gear.

Also on an UM2 you can't just push in a new filament while powered up because the stepper is energized.

What I did was cut the new filament end flat so it would have the most surface pushing against the broken piece. and manually fed it into the feeder while turning the dial to advance the filament in the "move material" menu option.

I did that just enough to get extrusion out of the nozzle, then I printed something unimportant to use up the broken piece.

As others have noted, until you get past the break, retraction doesn't work so the quality of the part suffers.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!