fingerpuk 0 Posted April 8, 2014 in Under extrusion? Hello, is this under extrusion or an issue in the geode? It's odd that it happens as a couple of odd layers then stops, the rest of the print i perfect. Share this post Link to post Share on other sites
ian 32 Posted April 8, 2014 in Under extrusion? it looks like funny gcode to me... did you try it with a different version of Cura ?... did you have a look at the layer view mode.. can you spot the difference ? it could be that the grass part under the belly of the elephant is badly intersecting with the belly itself and so causing some bad mojo on those layers... might be interesting to try the different combine bodies options in the advanced option of Cura... tell me what you find out... ? Ian :-) Share this post Link to post Share on other sites
gr5 897 Posted April 14, 2014 in Under extrusion? I think your z axis is acting up. Sometimes it is moving too far and sometimes not far enough. Share this post Link to post Share on other sites
fingerpuk 0 Posted April 16, 2014 in Under extrusion? It happened again today, looks like a lost layer. GCode looks fine though. :/ Share this post Link to post Share on other sites
