Cool head lift will *only* improve the 2 antennas. You can get even better antenna improvement by printing 2 robots side by side. The problem is they are so small they don't have time to cool as the nozzle is making physical constant contact and keeps them above melting temp. With "cool head lift" or by printing 2 robots the nozzle moves away long enough for it to cool. These are tiny improvements as they only affect the antenna.
You didn't answer the question about travel speed. What was your print speed and what was your travel speed?
I got the speed from Cura. At the Basic setting tab," Print Speed (mm/s) 30" . Advanced Tab, Travel speed (mm/s). So which is the one am I suppose to ensure correct? Please advice, thanks.
Recommended Posts
Top Posters In This Topic
23
13
7
5
Popular Days
Apr 23
23
Apr 17
8
Apr 13
7
Apr 14
7
Top Posters In This Topic
printedman 23 posts
gr5 13 posts
mnis 7 posts
illuminarti 5 posts
Popular Days
Apr 23 2014
23 posts
Apr 17 2014
8 posts
Apr 13 2014
7 posts
Apr 14 2014
7 posts
printedman 1
I have change to Expert setting and in Expert config tick the Cool head lift. default setting is:
Fan full on at height (mm) 1
Fan speed min (%) 100
Fan speed max (%) 100
Minimum speed (mm/s) 10
So do I need to change any setting? Please advice, thanks.
Link to post
Share on other sites