Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  

UM's bowden tube cannot be locked

Recommended Posts

Unfortunately, this standard couplings are not fit very much. The problem arises when short much more power is required for the filament transport than usual.

You have at least five ways to change something about it:

- There is a printable solution which keeps the Bowden better.

- You can cut the Bowden tube by a few millimeters, the coupling engages then better again in the material.

- Small rubber rings / O-rings on the coupling neck improve the holding force.

- A ring of shrink tubing can give the coupling more holding force.

- Some use proven pneumatic couplings (connectors).



Share this post

Link to post
Share on other sites

All of that is good. I like the "cut a few millimeters" solution but don't cut much more than that. Also make sure you loosen the 4 screws, shove it in there good, then after the clip is on and the bowden is tight, you tighten the 4 head screws a bit to make that bowden in there nice and tight.

If this solution doesn't work the first time, don't try it again - it probably means some of the metal knives in the bowden-holder are broken. So try one of the other solutions.


Share this post

Link to post
Share on other sites

Another vote for cutting off a few mm of the bowden. Try to make the cut as square as possible for good measure. (remember when it had to be absolutely perfect guys? Those were the days...)

BUT, before you try to re-assemble everything, remove the coupler and look inside it. Since you have scraped the bowden several times there's a big chance that there's ground up pieces of bowden material stuck in the little metal blades that are meant to bite into the tube. Clean that out as best you can with a needle or something along those lines. Also check that the blades look ok in general (not pushed in or missing).


Share this post

Link to post
Share on other sites

I snapped my bowden clip during assembly - Ultimaker have been great about getting a replacement out to me, and the machine (UM:Original) functions. First print off was the more robust bowden tube holder here:

http://www.thingiverse.com/thing:17027 - you will want to counter sink the extruder side of this otherwise feeding the plastic in is fiddly and its easy to gouge the filament in the process.

There are a number of refined versions of this so have a dig around.

Down side is if the hot end clogs horror results rather than the bowden clip popping off. It'd be good if the extruder assembly mounted a force sensor to try and detect gratuitous jams ("danger Will Robinson, danger!").


Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!