Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  

idea for improved startup sequence

Recommended Posts

Most of the time I print with a heated bed, which takes a few minutes to warm up. The GCode that is generated by Cura makes the printer warm up the bed and the nozzle at the same time. The nozzle is at setpoint within a minute, and starts oozing for a few minutes, because the bed is not ready yet. This causes a bad start of the print.

The trick that I am doing manually is that I put the (glass) bed against the nozzle, so that it is closed. I do this when the nozzle is at the XY home position. This is important, otherwise the homing action of the printer after heating would drag the head accross the glass bed to the home position.

Today, I thought that this simple trick (closing the nozzle with the glass bed) could be done automatically. This might be built into Cura.

How do other folks handle the oozing of the nozzle during heating of the bed?


Share this post

Link to post
Share on other sites

As I have an UM1 with a heated bed, I work in RepRap flavour. Thus, I have a start.gcode where I can determine the order in which hotend and bed are heated. I first heat the bed and then the hotend, so I don't have any significant oozing.

The same thing would be possible with an UM2 when the flavour is switched to RepRap from UltiGCode.


Share this post

Link to post
Share on other sites

I'm assuming this is on an UM2 since you mention a heated bed? If so, when did you last update the firmware? The heat-up sequence has been that the bed starts heating up and the head doesn't heat up until the bed is almost up to temperature for quite some time now.


Share this post

Link to post
Share on other sites

I have a home made heated bed on an UM1. I use hardened glass, so I don't think the hot nozzle against the plate is a problem.

I'll modify the startup lines to heat up the bed first.

Related question; what does T0 mean in the line


M109 T0 S190.000000


Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!