Jump to content
Ultimaker Community of 3D Printing Experts

Recommended Posts

Posted · UM2 OLED glitches?

Does anyone else's UM2 OLED display "glitch" ? By which I mean the entire screen image jumps to the right by about 10-20 pixels briefly and then goes back to normal. It's like when horizontal sync would fail on an old analog TV. It only does it once or twice every few minutes, only for a split second, and it's working fine otherwise. It doesn't matter what is being displayed, and it will do it while I'm navigating menus.

It does seem to get better or worse at different times.. sometimes it does it more, sometimes not at all... Which makes me wonder if it's a power supply hiccup or issue with the OLED. Or maybe it's a communication / timing issue with the OLED display? I haven't (yet) been able to correlate those differences in its manifestation to specific machine states (printing / high temperature / lots of movement / etc)

Just wondering if others have seen this or not, and if it's any cause for concern.

I'm using the firmware that comes with Cura 14.05RC4

 

  • Link to post
    Share on other sites
    Posted · UM2 OLED glitches?

    I've handled a lot of printers and I've seen it from time to time, but it's fairly rare. It has never been an issue when it comes to functionality though. I wouldn't worry unless it starts freaking out constantly and interferes with your ability to operate the printer.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Ultimaker Transformation Summit
        Visit our virtual showroom and learn more about the Ultimaker ecosystem!
        • 14 replies
      • New here? Register your Ultimaker for free 3D printer onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 0 replies
    ×
    ×
    • Create New...