Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  
david-ganon

need help with bad prints...

Recommended Posts

That's just the nature of this particular printing technology. Imagine this, paint a plank with a thick layer of thick paint, now lay that plank down on top of gravel and let the paint dry. What happens? The gravel digs into the paint and leaves big marks in it. This is basically the exact same thing that happens with FDM printing.

 

Share this post


Link to post
Share on other sites

David,

Have you had a play with the support settings? (goto expert setting)

I usually use 'line' supports as they are much easier to remove, but they are not a stable as the grid.

It looks like you need more support try adjusting the percentage of support up to 30% this will mean the extruding plastic has less distant to bridge when printing the first layer over the support.

Finally i set the 'Z' offset the same as the layer height i am printing at. for example if I print at 0.1mm layers the Z offset is the same.

I hope this helps

Bob

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!