UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
No, it's fairly normal for these fans to resist starting at lower speeds. The firmware should do a better job of kickstarting them. Usually if you just get them started by hand they will spin up ok. But to be honest, you really only need to run them at full speed for most things.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
Recommended Posts
illuminarti 18
No, it's fairly normal for these fans to resist starting at lower speeds. The firmware should do a better job of kickstarting them. Usually if you just get them started by hand they will spin up ok. But to be honest, you really only need to run them at full speed for most things.
Link to post
Share on other sites