Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  

Question about filament loading in Cura 14.07

Recommended Posts

What happens, is that people that move their printers a lot, they use the change-material to remove the material. But then half-way shut off the machine, so they can transport the machine without a roll attached. However, they have to go trough the whole procedure again to load the material again. So I made a quick option which skips the first half of the change material.

(Also added an option to reduce the motor current in the motion settings. Not really useful for daily use, but could be useful if you replace the extruder stepper motor with something else)


Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  


Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!