Jump to content
Ultimaker Community of 3D Printing Experts

UltiController on 1.5.6


blackice83

Recommended Posts

Posted · UltiController on 1.5.6

Hello!

I have got a question. I can control my Ultimaker perfectly with UltiController. But the mainboard is not selfpowered. Do I need a patch with version 1.5.6?

http://wiki.ultimaker.com/Patch_for_self_powering_old_electronics

 

However, for older electronics (under version 1.5.6) it is needed to patch the electronics to be 'self-powered' i.e. power the Arduino and UltiController from the 19V power adapter. Otherwise you still need to power it over USB.

thank you.

  • Link to post
    Share on other sites
    Posted · UltiController on 1.5.6

    It should not be needed on 1.5.6 electronics. You should have a ARDPWR jumper somewhere, maybe it's not connected on your board? This jumper makes the main board self powered.

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...