If you are Intressted in this Topic you might want to follow this Thred: http://umforum.ultimaker.com/index.php?/topic/7136-exploring-marlin-bed-auto-level/
Fabian
If you are Intressted in this Topic you might want to follow this Thred: http://umforum.ultimaker.com/index.php?/topic/7136-exploring-marlin-bed-auto-level/
Fabian
Recommended Posts
mnis 11
Tried? No. In thinking a few times? YES.
Since Cura 14:07 including firmware, there was no longer any need for me so far. I print almost daily. Everything liable super on the glass, the contact surfaces look very good. Therefore, I believe that automatic bed-adjustment is a good thing, but really is little need for it, I think.
:idea: When I see later need for it, then I opt for the solutions with Hall sensors.
For what are the three screws under the bed? Damn... :wacko: :rolleyes: :lol:
Markus
Link to post
Share on other sites