Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up
Sign in to follow this  
nigel

Initial layer Density Issue Also Over Heating on Fine Detail Areas

Recommended Posts

Posted · Initial layer Density Issue Also Over Heating on Fine Detail Areas

Hi Guys,

Im wondering if there is any way of getting a more uniformed lower layer like whats seen on the outside of the model, mine seems to have no overlap and im not sure why.

I am also getting melted PLA on the fine detail areas at the point. I have tried increasing minimum layer time from 0 to 6 to 10s. With 10 you get stringer build up as the nozzle sits in one spot waiting on each layer. Is there anything i can change im my setting to make this work better. Please see photos below for bottom layer and setting

Capture3

Capture2

Capture

20140717 175506

20140717 163158

20140717 150851

 

Share this post


Link to post
Share on other sites
Posted · Initial layer Density Issue Also Over Heating on Fine Detail Areas

I would print the levelling square, let it cool the remove it and measure you leveling with calipers. It should be .3 or a little less like .25mm for a little extra "squish".

Also, I've seen similar results when the nozzle was partially blocked.

Might help if you print with brim or increase the skirt size so that the nozzle is at the right pressure before printing the part.

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • Ultimaker Essentials
      Ultimaker Essentials is an enterprise-grade package of Ultimaker software products with greater stability, uniformity, and a higher level of security. 
      • 0 replies
    • Cura settings: Improving naming and descriptions
      - Maybe you'd like to see more detailed descriptions for each setting?
      - Maybe you'd like to see some settings in a different category?
      - Maybe you'd like to see a completely new category?
       
      Give us your feedback in this thread and we'll consider it for future releases.
        • Like
      • 6 replies
×
×
  • Create New...