Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  

UM2 print head scratching up wall at Home position

Recommended Posts


I've had my printer for about a month or two, but more recently I've noticed a scratching sound at the beginning and end of printing. While working on a print I checked the home position and noticed the wall is being scratched by the fan of the print head. Due to this, one of the fans is being warped upwards.

IMG 7218

IMG 7219


Any idea what caused this, how to fix it and what I can do to prevent it in the future?

I'm wondering if the firmware update caused this, as I haven't touched or modified any of the hardware. If it's not that, then I think it might be accumulating error from the stepper motors.

But there should be an encoder to fix that should there?

Also why didn't the limit switch trigger?


Share this post

Link to post
Share on other sites

Yes, bend back the fan. Also after bending it back listen for the limit switch and make sure when it clicks there is still a gap between the fan and the wall. If not the limit switch may have moved or it may be broken. If the limit switch is broken it is obvious because homing the X axis would be incredibly loud. It does the "death rattle" when the limit switch isn't working.

Still the switch may have moved and you might want to bend it back by .5mm or so after you bend the fan duct back.


Share this post

Link to post
Share on other sites


I ended up just sticking a piece of PLA in between so the limit switch would trigger earlier.

Does this offset the dimensions of the build area though? (Not that I would print all the way out to the edge anyways)

How would the printer know when it hits the opposite edge? I don't see any limit switches for that side. Is that software based in the printer settings of how big the build area is?


Share this post

Link to post
Share on other sites

The printer has "software end stops" enabled. So, yes, it's a software thing. I forget the XY dimensions but I think 225 and 235mm. You can command the printer to go to various positions (220,225,230,235) and see if it hits the other side. You won't break anything. The printer is tough that way - many times I've moved X or Y axis farther than it's supposed to go. It makes a loud scary noise but nothing is damaged.

You can hook up the printer do your computer with USB, go to print window in Cura and configure it for "pronterface" mode and then send gcodes:

G0 X10

moves X axis to 10mm from home position.


Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!