Adding partial brim to a model

[coffeecup 1]

I am trying to print a model with a small part which is difficult to adhere to the platform (such as the Torture Test).

I don’t want to turn on “brim” in Cura because the other part of the model does not need brim to print.

Is it a simple way to add brim or support disc or whatever to a part of a model so that it can adhere to the platform better?

Thanks for any input.

Torture test: http://www.thingiverse.com/thing:33902

 

[zoev89 73]

Not in Cura. The easiest way would be to just add a small disk to your model where it needs the brim. Instead of looking for a tool that can generate it for you.