Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  
thirty6

uni controller

Recommended Posts

Hi All

Uni controller has started to display weird digits, unsure if it will have an effect on the actual prints but it did stop last night mid run.

Recently fitted a heated bed and updated the firmware but that was last week and it had been running fine till now.

Where do i need to start looking??

IMG 0732IMG 0733

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×

Important Information

Terms of Use Privacy Policy