Jump to content
Ultimaker Community of 3D Printing Experts

Recommended Posts

Posted · Rough Edges, why?

This is the bottom layer. Does the next layer look better? For ABS try 245C instead of 260C. Also I recommend bed temp of 100C.

I'm not sure what the edge is - it might be overextrusion or dripping - leveling might be too high (but that will be fixed on second layer so try second layer). Might be flowing too freely at 260C.

 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...