UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
As far as I know this works fine (with any Cura version), if you use Sprinter or Marlin firmware. I don't know the perfect start/end code, but I wouldn't even be surprised if the default works.
Note that there are lots of Mendel90 users on IRC at #reprap on freenode. So they might be better at assisting you then we are.
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
Recommended Posts
Daid 304
As far as I know this works fine (with any Cura version), if you use Sprinter or Marlin firmware. I don't know the perfect start/end code, but I wouldn't even be surprised if the default works.
Note that there are lots of Mendel90 users on IRC at #reprap on freenode. So they might be better at assisting you then we are.
Link to post
Share on other sites