Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  

White PLA: Fussy to print with?

Recommended Posts

I was previously using silver PLA on the default UM2 print settings with great results.

White PLA seems to be altogether more "fussy" - strings, blobs and pillowing all in evidence on my last print. Changing the nozzle temperature to 190C helped a lot as well as setting the wall thickness to 1.2mm and the print quality to high quality print.

The results still aren't anywhere near as good as with silver (both PLA are from UM and of similair age (~3 months)/storage conditions etc.,)

Has anyone else found white PLA "more fussy" to print with than silver for instance?

If so, any tips? Cheers!


Share this post

Link to post
Share on other sites

White PLA from Ultimaker? Personally I've found it to be my most reliable (least fussy) filament of late. I'm printing at the default temp - 210C I think.


210C really? That causes it to first of all run, then bubble and spit for me. I had to lower the temperature. 190C seems to give me the "best" prints so far. The label is Ultimaker 2.85mm white (9016-Z1C-A) (on a side note I wish I could get the UM to stay at 190C it always defaults back to 210C which is a right royal pain)


Share this post

Link to post
Share on other sites

I'm not getting any of those problems with it. Could you have a faulty temp sensor?


Thought did cross my mind, but the readings always appear stable and whatever I set the temperature to tallies with what is "read back" Silver prints just fine.... could I have a dodgy reel of the white stuff ??


Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 114 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!