Jump to content
Sign in to follow this  
mariuszem

extruder switched off. maxtemp triggered !

Recommended Posts

Posted · extruder switched off. maxtemp triggered !

Hi, after full assembly, when I connect UM to my Mac, to ReplicatorG 0.35, I got error message: "extruder switched off. maxtemp triggered !". Should I try to put RED temp sensor wire to left, and YELLOW to right (step 4 - extruder, 35)?

In control panel I got stepper-based pinch extruder: 24C

Share this post


Link to post
Share on other sites
Posted · extruder switched off. maxtemp triggered !

I updated firmware, and facing now other problems, so that one is solved:)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!