Hallo everybody,
who is using the olson block with the 35W heating element from 3Dsolex? Do you need this enhanced power due to the fact that the olson block is longer ?
I want to do ABS on long-lasting prints and I am currently still on stock (um2).
Thanks and regards,
Nils
Recommended Posts
mechamecha 64
shurik - I did change my Teflon insulator recently, but it was when I still had the stock heater block/nozzle installed, and it didn't make an appreciable difference. So now I have the new Teflon insulator, Olsson block and RSB nozzle installed, and my UM2 is working great!
Link to post
Share on other sites
personal-drones 44
Don't forget to install a I2K Insulator to prolong the life of the teflon coupler
Link to post
Share on other sites