Jump to content
Ultimaker Community of 3D Printing Experts

infill not connecting to the outlines


Recommended Posts

Posted · infill not connecting to the outlines

If you happen that your infill isn't connecting to the outlines, and you have already set a reasonable overlap (in i.e. cura) to 15%, and your belts are already tight, check if your set screws on the XY stepper axis are properly tightened, especially if you have a D-shaped axis. if the set screw isn't perpendicular to the flat side, it will cause a tiny bit of backlash when the stepper changes direction. don't overtighten the setscrew, since it would damage the threading.

  • Link to post
    Share on other sites
    Posted · infill not connecting to the outlines

    Yes I do get this, which ones are the "set screws"?

    After moving into my friend's office, the machine is experiencing daily "thermal cycling" from 14C during the day to 29C at night, which I believe is causing it's belts to loosen and the frame to distort very slightly - which is affecting the quality of prints.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...