keeping the heated bed on without power is a bit difficult I guess
you could buy a UPS ....
http://www.apc.com/site/products/index.cfm/homeoffice/?segmentID=1
keeping the heated bed on without power is a bit difficult I guess
you could buy a UPS ....
http://www.apc.com/site/products/index.cfm/homeoffice/?segmentID=1
Indeed :mrgreen:
I have a small UPS on my printer to avoid micro power fails (they happen quite often in my area). I'm not sur how long it can hold tough
If you want a ups to be a bit affordable 10 hr prints without power wont be an option.... but 15 minutes or so should be doable... for maybe 3 to 4 hundred euro.... still a lot more money than a few failed prints..
Recommended Posts
DidierKlein 729
It is possible, not simple but possible.
First thing to make sure is leaving the heated bed at temperature (if you're printing with it) to avoid the print to detach.
I'll search the forum for the procedure give me 5 minutes
http://umforum.ultimaker.com/index.php?/topic/6802-2-ways-to-resume-print-from-last-layer
http://umforum.ultimaker.com/index.php?/topic/4213-ideas-for-recovering-failed-prints/?p=34788
http://umforum.ultimaker.com/index.php?/topic/5269-um%C2%B2-printing-more-than-24-hours-non-stop/?p=46704
Hope it helps
Link to post
Share on other sites