Jump to content
Ultimaker Community of 3D Printing Experts

Print interupted due to power failure. Didn't have a backup power.


Recommended Posts

Posted · Print interupted due to power failure. Didn't have a backup power.

It is possible, not simple but possible.

First thing to make sure is leaving the heated bed at temperature (if you're printing with it) to avoid the print to detach.

I'll search the forum for the procedure give me 5 minutes

http://umforum.ultimaker.com/index.php?/topic/6802-2-ways-to-resume-print-from-last-layer

http://umforum.ultimaker.com/index.php?/topic/4213-ideas-for-recovering-failed-prints/?p=34788

http://umforum.ultimaker.com/index.php?/topic/5269-um%C2%B2-printing-more-than-24-hours-non-stop/?p=46704

Hope it helps

 

  • Link to post
    Share on other sites
    Posted · Print interupted due to power failure. Didn't have a backup power.

    If you want a ups to be a bit affordable 10 hr prints without power wont be an option.... but 15 minutes or so should be doable... for maybe 3 to 4 hundred euro.... still a lot more money than a few failed prints..

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...