Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
das Stringing kann auch daran liegen, dass du eventuell ein anderes Material verwendest und die Temperatur dafür etwas zu hoch ist. Probier mal folgendes, lade dir (oder bau es dir kurz selbst) ein kleines gut geeignetes Testobjekt für Stringing runter. z.B. zwei 5mm Säulen im Abstand von 2 cm oder so. Drucke das mit deinen normalen Einstellungen. Dann senke alle 5mm die Temperatur des Hotends um 5°C ab. Meistens findest du dann eine Temperatur bei der das Stringing stark abnimmt oder im Idealfall komplett verschwunden ist. Diese Temperatur nimmst du dann als Ausgangspunkt und erhöhst sie wieder leicht, bis du den Punkt wo das Stringing anfängt exakt hast und leicht, 2°C oder so drunter bleibst. Es gab zu dem Thema auch einen Post von gr5 wo er das mit Bildern dokumentiert hat.
Hoffe das hilft dir weiter. Viel Spaß beim Experimentieren.
We don't often release an alpha version of Ultimaker Cura... So what's different this time? This Alpha contains such a huge slicing engine overhaul that we really need your help!
We wish to celebrate and honor the innovators that push forward the field, technology and world. We opted to not present it as a competition or ranked list. Every innovator has earned his spot on that list in their own way. We also look at the 3D printing industry as a whole and not limit the list to those only using Ultimaker.
Recommended Posts
duesentrieb 0
Moin,
das Stringing kann auch daran liegen, dass du eventuell ein anderes Material verwendest und die Temperatur dafür etwas zu hoch ist. Probier mal folgendes, lade dir (oder bau es dir kurz selbst) ein kleines gut geeignetes Testobjekt für Stringing runter. z.B. zwei 5mm Säulen im Abstand von 2 cm oder so. Drucke das mit deinen normalen Einstellungen. Dann senke alle 5mm die Temperatur des Hotends um 5°C ab. Meistens findest du dann eine Temperatur bei der das Stringing stark abnimmt oder im Idealfall komplett verschwunden ist. Diese Temperatur nimmst du dann als Ausgangspunkt und erhöhst sie wieder leicht, bis du den Punkt wo das Stringing anfängt exakt hast und leicht, 2°C oder so drunter bleibst. Es gab zu dem Thema auch einen Post von gr5 wo er das mit Bildern dokumentiert hat.
Hoffe das hilft dir weiter. Viel Spaß beim Experimentieren.
Viele Grüße,
Philip
Link to post
Share on other sites