Moved and now have problems

[pdrinkut 3]

Hi all, I had my printer setup and dialed in perfect, gave me no problems. Then I moved, after setting the printer back up I've had nothing but issues. I've checked the visual troubleshooting guide but didn't see anything like what I have.

The problems are very random, if i try to use a brim the first line that prints is fine then it starts getting globby and there's no solid lines. If I try a raft first layer pritns fine then it all goes to hell. I've tried the extrusion test and it printed fine for some reason. I've included a picture of a raft, don't have one of a brim yet. I've tried different materials, temps, speeds, I have no clue what is going on and I'm at my frustration limit.

 

 

 

 

[gadgetfreak 7]

Sounds like it might be something wrong with the temp sensor...if it's that random? Check for loose cables on the electronics board. How old is your machine?

[gadgetfreak 7]

Sometimes after transport, cables could get loose from vibrations, that's my hunch without more info.