Jump to content
Ultimaker Community of 3D Printing Experts

Relation between full step length and layer height


Nicolinux
 Share

Recommended Posts

Posted · Relation between full step length and layer height

I am setting up my 3DR delta printer and while tinkering with Slic3r I came across this statement regarding z-wobble and how to counter it:

Undulations in the walls of a print may be due to wobble in the Z axis. A thorough analysis of the potential causes is given by whosawhatsis in his article "Taxonomy of Z axis artifacts in extrusion-based 3d printing", however one point of particular interest for users of Slic3r is the wobble caused by motor steps not matching the pitch of the Z rods thread. This can be addressed by ensuring the Layer Height setting is a multiple of the full step length.

Source:

The question is - what is the full step length for an UM2 stepper?

 

  • Link to post
    Share on other sites

    Posted · Relation between full step length and layer height

    My question is, if we cannot rely on microstepping on Z, why could we on X and Y.

    I accept that, in general, dimensions in X and Y are larger, hence the error is less significant.

    But the point is that everybody is calculating resolution taken into account microstepping as well.

    So, the 5 microns (perhaps 1/8 microstepping?) that UM2 specification claims on Z are reliable or not?

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    ×
    ×
    • Create New...