Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  
doc-biber

Problem beim Zusammenbau DIY mit resiliert coupling

Recommended Posts

Hallo,

ich baue zur Zeit an meiner Schule mit einer Klasse 4 Ultimaker DIY zusammen. Wir haben am DOnnerstag mit der ersten Bauphase begonnen und den Zusammenbau des Rahmens/Gehäuses in Angriff genommen. Bei 3 Bausätzen gab es keine Probleme. Beim 4. wollte die resiliert coupling, also die Wellenkupplung für den Z-Achsenmotor, nicht passen. Die Öffnung ist offensichltich zu eng.

Für Vorschläge, was ich tun soll, wäre ich sehr dankbar!

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 117 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!