Jump to content
Ultimaker Community of 3D Printing Experts

Problem with Spiralize the outer contour.


jangermann

Recommended Posts

Posted · Problem with Spiralize the outer contour.

This is my first vase attempt with Cura, and I am not happy :sad:

When printing, the extruder stops for a very short time, every round of the vase, this leaves a small dot.

It leaves a spiralize path of dots on the print.

Is this a Cura 14.09 bug??

Trying to print this model (it is solid and should be OK)

http://www.thingiverse.com/download:114887

Se the problem here:

path1.jpg

path2.jpg

Why oh why?

 

  • Link to post
    Share on other sites
    Posted · Problem with Spiralize the outer contour.

    Looking at the rebuilt version it in layer view you will see the toolpath switching from inner to outer shell. That vase is too thick to be printed in one pass with spiralize.

    The solid version seems a better fit.

  • Link to post
    Share on other sites
    Posted · Problem with Spiralize the outer contour.

    Thanks for your answers.

    I will try V14.12 to night and post the result.

  • Link to post
    Share on other sites
    Posted · Problem with Spiralize the outer contour.

    I did one last night but with 14.07 and it was fine.

     

  • Link to post
    Share on other sites
    Posted · Problem with Spiralize the outer contour.

    I can now confirm that V14.12 is fine.

     

  • Link to post
    Share on other sites
    Posted · Problem with Spiralize the outer contour.

    Then this is most likely the result of the path order bug in 14.09, which is fixed in 14.12

     

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...