Jump to content
Ultimaker Community of 3D Printing Experts

Cannot move to negative position


Recommended Posts

Posted · Cannot move to negative position

Just built my Ultimaker, but while doing some primary tests with moving the extruder head in RepG, I notice that the jog values don't work when they go below 0. This means that I cannot move the print bed up above it's position position from when it was turned on. It's not that I cannot move it in one direction, because if I go to 1, I can move back to 0, but not -1. Is this normal behaviour?

  • Link to post
    Share on other sites
    Posted · Cannot move to negative position

    It's normal behavior with software endstops enabled. Guess the default Ultimaker firmware has this. You need to use the home function first (if that is available in RepG, been a long time that I used RepG)

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...