[[Template core/front/global/favico is throwing an error. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]] Jump to content
Ultimaker Community of 3D Printing Experts

What are shells and how to create them?


spooner777

Recommended Posts

Posted · What are shells and how to create them?

"Shells" referrer to the amount of outer lines the printer makes. 5 shells is a LOT, and saying "you need X shells" actually means that you need a certain wall thickness, as the width of each shell depends on your printer (0.4mm for a default UM, but 0.5mm for most RepRaps)

So if something says you need a lot of shells, you need to configure Cura to make a thicker wall.

  • Link to post
    Share on other sites
    Posted · What are shells and how to create them?

    On that note, wih particular reference to Cura, what options have I got for controlling the number of shells?

    The nozzle diameter is 0.4 mm, but it can print thinner, though I gather less than 0.3 is considered problematic?

    I can fiddle with wall thickness, which has an effect in the number of shells, thus should I be setting my wall thicknesses to multiples of 0.4? What happens when I set it to 1 mm? Do I get 2 shells and a bit of fill? Or is Cura smart enough to do two shells of 5mm?

    I've tried KISSlicer and it produced very nice edges - it allows you yo specify the number of shells - but I much prefer the infill and support settings in Cura

  • Link to post
    Share on other sites
    Posted · What are shells and how to create them?

    I have a test-object where we print 0.2 mm through 1.6 mm cylinders with 0.2 steps. The 1mm one always comes out more or less as two separate cylinders, an inner one and an outer one.

  • Link to post
    Share on other sites
    Posted · What are shells and how to create them?

    If you must print cylinder it's lite tricky. You must experimaent with the settings and see the slicer result in Cura (without printing it). Only view the 3D Model how it "will" print it.

    Change you nozle size to 0.2 and low Shell size. This will make fill the inner side and not only the 2 walls.

  • Link to post
    Share on other sites
    Posted · What are shells and how to create them?

    I have not tried changing the nozzle size in Cura. Is it something that should be fiddled with, or should it always be set to the size of the real nozzle?

  • Link to post
    Share on other sites
    Posted · What are shells and how to create them?

    You'll get the best results if you leave it at the real nozzle size, but some people like to experiment with it. If you lower it, then Cura will try to put down thinner lines, which is hard. If you increase it cura will put down thicker lines, which will put more pressure on your nozzle.

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...