Jump to content
Ultimaker Community of 3D Printing Experts

First infill then walls?


Recommended Posts

Posted · First infill then walls?

this is really not good.... first the lines from infill are shown on the walls and second the nozzle is bouncing on the cooled down palstic. If there is a need for this then make it like a option to turn off or on.

thanks

 

  • Link to post
    Share on other sites
    Posted · First infill then walls?

    I like it a lot. Now the outer perimeter has much better surface quality without the little "blobs"

    Why you should see the infill lines? Normally the infill only overlap 15% the inner wall.

    There is no different whether the infill is done before or after the perimeter. While combing the nozzle will cross the infill.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...