That seems strange, unless your "leitbahn" originally was only 1 pass at 0.1mm.
Could you bring it further by increasing layer height?
Do several layers combine electrically?
That seems strange, unless your "leitbahn" originally was only 1 pass at 0.1mm.
Could you bring it further by increasing layer height?
Do several layers combine electrically?
No, it is a bigger part and it doesn't really matter where i attach the measuring tip..
The last Olson block i ordered, is for this machine to go and try 0.8mm wide and 0.5mm hight
Yes it combines well as i tested different layers/heights connecting in the print, i will test top to bottom and same line next time and write it down to have a better answer :cool:
i try to imagine how this works that layer height effects the conductivity so much but no luck so far :mad:
For people who wants to print this conductive pet:
Switch off Combing!
It makes a lot of drops and chunks around the print and..
..without it just prints very well @ 250-260° on kapton tape and 75°C bed , fan <50%
Hi Visu-al,
In my understanding, it is possible to use the ESD filament but its hard to control it, so, do you recommend to use it or not?
Hi, How was the surface finish on these fillers? =)
Magne,
Norway.
Recommended Posts
visu-al 2
changing to 0.2mm layer height instead of 0.1 changed conductivity from around 200kOhm to around 20kOhm !
Link to post
Share on other sites