Merci les gars, je vais tester ca prochainement....
oui ça pourrait être cool comme plugin mais un problème persisterait.
La taille de la tête d'impression est beaucoup plus grande que la taille de la buse. De plus la buse est en entonnoir donc il serait impossible d'imprimer très prêt d'une surface vertical.
Je pense que par "noyée" on attend "incluse" dans l'impression comme un roulement, un écrou.
On imprime jusqu'à l'empreinte, on met le pièce et on ferme en recouvrant...
Bonjour,
J'ai utilisé ce plugin pour la pose d'un écrou sur mon porte gobelet.
https://www.youmagine.com/designs/porte-verre-gobelet-plastique
https://d36c0vbvwjb9cx.cloudfront.net/uploads/image/file/70562/large_Insert-M3.jpg
Fred
-
Our picks
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 18 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
Release Notes: S-Line Firmware 8.3.0 (Latest)
Dustin posted a topic in Firmware,
S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
(Sorry, was out of office when this released)
This update is for...
All UltiMaker S series
New features
Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.-
-
- 0 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
darkdvd 975
Le plugin "pause at height" permet de faire ça.
Tu le configures pour mettre l'impression en pause à une certaine hauteur : la tête va se déplacer des valeurs X et Y que tu détermines afin de te laisser la place d'intervenir sur l'impression.
Tu relances ensuite l'impression.
ATTENTION à bien avoir fait tes mesures car la moindre collision avec la tête et la buse peut faire de gros dégâts !
Link to post
Share on other sites