Infill with holes (mesh)

[crazybird 1]

Hi everybody! I'm new around here and with the printer.

My problemo (Terminator) is that the infill of the part looks a little bit shitty to be honest... the walls have an amazing quality, dimensions tolerance quite nice but the infill... chsss

This photo is at:

LH: 0.16

ST: 0.8

ER: Yes

B/T T: 0.6

Fill density: 15%

P S: 50mm/s

(sorry for the image quality, digital zoom on mobile phone...)

 

[DidierKlein 729]

Hi and welcome to the forum,

Have you printed with one of the quickprint profiles?

If yes sometimes the infill speed is too high (it was corrected in the latest Cura i think).

You can lower the infill speed by going in expert mode then in the advanced tab