Print issue after updating to Cura 15.2

[frank-pitkat 0]

Existing file prints fine (pre-15.1 gcode file). Made some minor adjustmets to the supports in the print with Cura 15.2 and now i'm getting some overlap on some of the edges.

Tried re-leveling and reloading filament but still prints the same.

Take a look at the picture at the link below.

https://www.dropbox.com/s/rmu7sqzd2p0hwqc/2015-02-28%2023.26.30.jpg?dl=0

Settings-

Layer height: 0.15

Shell thinkness: 2.0

Bottom/Top Thickness: 1.2

Fill Density: 20

Print Speed: 40