www.thingiverse.com/thing:230746
Thank you for your reply. in the bottom layers it fills in the bore where the indicator goes. then it opens back up. when it goes back to doing the top layer it fills in the bore again.
www.thingiverse.com/thing:230746
Thank you for your reply. in the bottom layers it fills in the bore where the indicator goes. then it opens back up. when it goes back to doing the top layer it fills in the bore again.
Try unchecking Expert Settings > Fix hirrible Type-A
Go to layer-view to see if the problem persists.
Thank you Bagel Orb. That did the trick. printing just fine now
Recommended Posts
printedman 1
Can give a link to the item from thingiverse?
Link to post
Share on other sites