Jump to content
Ultimaker Community of 3D Printing Experts

PLA Spool Lifespan


Recommended Posts

Posted · PLA Spool Lifespan

Hello All.

New to the forum and ultimaker.

We've bought and ultimaker 2 for our design office a bout 2 months ago, loving it so far. But I've noticed we've started to get some build problems with one of our spools of PLA. The drive motor sounds like it skips (a but like a hiccup) and we're getting very patchy prints. I've cleaned the nozzle out and we're not having the same problem with the other spool we got with the machine, so I'm assuming the PLA has degraded. This particular spool was sealed in a plastic bag with a silicon gel pack when we received it so it's only been open to the elements for max 2 months.

How long do you find the PLA spools normally last before they showing signs of degrading?


  • Link to post
    Share on other sites

    Posted · PLA Spool Lifespan

    I have spools that I've had for a couple of years at least and they work just fine. It could be that you're reaching the center of the spool which is wound more tightly which causes more friction in the bowden tube.


  • Link to post
    Share on other sites

    Posted · PLA Spool Lifespan

    +1 for what Robert said. It sounds more like your filament is reaching the center of the coil, which means that the filament is tighter and the feeder has to work a little harder to pull the filament, causing your feeder to skip. You are not getting the same problem with your other spool... because its not at the centre.... YET :)


  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now

    • Our picks

      • The Ultimaker Showcase — October 14. What's new?
        Your dear friends at Ultimaker have some exciting news and insights for you!
        • 0 replies
      • New here? Get ahead with a free onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    • Create New...