Jump to content
Ultimaker Community of 3D Printing Experts

Clicking upon extrusion.


liberty
 Share

Recommended Posts

Posted · Clicking upon extrusion.

I am not sure if anybody else has posted on this issue but I have not seen it.

When I start up my machine everything runs fine, no troubles there.

When I start to print there is a clicking noise and only about 1/2 the amount of plastic comes out.

The same happens when I go to advanced maintenance and "move material"

BUT when I attempt pushing the plastic through on my own it extrudes normally.

I have tried disassembling the rear stepper assembly and the extruder assembly with no luck. I cleaned the thing to a spic and span. (the machine is very well taken care of and I only print with PLA)

I tried updating the firmware and every solution I could think of. Even replaced the entire extruder/heating block, and the silicone guide tube.

If anyone has any ideas or solutions for what is going on any help would be greatly appreciated. The printer has been down for months now and still have not been able to find a fix.

 

  • Link to post
    Share on other sites

    Posted · Clicking upon extrusion.

    i'm having a similar issue that i'm trying to find help with. i just unboxed my um2 and have printed the urobot guy twice and since then have not been able to get a good start to a print. :(

    i had a hard time getting my PLA into the feeder the very first time (following instructions written and video). got it in and had the knocking.

    i did see the upgraded filament feeder and went to print it out and since that point i can't get any of my prints to stick to the bed, just bunches up on the extruder.

    also found a post about the firmware 15. someone upgraded and then had these problems then put it back to 14 and all was well again. not sure if that is a fix to our problems.

    the community around the ultimaker seems really awesome so i'm sure someone can help us out.

    edit/update:

    i got the feeder printed out finally and wow what a difference! i'm using the latest firmware and it's all good! a huge thank you to the community and https://www.youmagine.com/users/iroberti for putting together such an awesome fix! the printer now feels like a 'out of the box and print' solution. this is why i got a printer... the ability to print upgrades and the brain power of the world working towards making the product the best it can be!

    cheers

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...