Jump to content
Ultimaker Community of 3D Printing Experts

Recommended Posts

Hello,

I have an STL file that is a single part that I would like into two part (top and bottom)

So is there a way in Cura 15 that I can set the Z height to stop or start generating gcode at.

Many thanks imk

PS if Cura can't it would make a nice addon

 

  • Link to post
    Share on other sites

    Go to the advanced tab, under the Quality section you will see "cut off object bottom". Tell it how many mm you want to cut off and you will see the model sink into the print bed. This sorts the top half. Then the success of the bottom half will depend on the shape of your model; rotate the model 180 degrees about the Y axis and again cut-off the model.

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...