Jump to content
Ultimaker Community of 3D Printing Experts

4th grade landforms project

Recommended Posts

  • 2 weeks later...
Posted · 4th grade landforms project

Thanks looking at the videos!

About the infill. The cave certainly did not need the high infill, but some of the prints have big flat surfaces that we needed to be smooth, I usually would use

Layer height = 0.2mm

top bottom thickness = 0.8mm

infill = 17-20%

I have not had good luck getting flat tops with less infill.


  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Create New...