Jump to content
Ultimaker Community of 3D Printing Experts

Ulticontroller goes to "Sleep..."


mmacrobert

Recommended Posts

Posted · Ulticontroller goes to "Sleep..."

My Ulticontroller keeps going to "Sleep..." at random intervals after beginning a print. How do I wake it up?

It stops a print ruining the process, sometimes 3 hours into a 8 hour print. I can't keep using the controller.

I'm using board v1.5.4, Win7 Cura. I'm running the GCode direct from SDcard.

Martin

  • Link to post
    Share on other sites
    Posted · Ulticontroller goes to "Sleep..."

    Most likely it's a MINTEMP or MAXTEMP trigger, which is not correctly reported to the display (that sucks, I know)

    It happens because of a bad connection to the temperature sensor, so you might want to double check those connections. However, it should also happen with USB printing.

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...