You wont be able to print in on UM2 unless you change your firmware to remove the 260C heater limit
You wont be able to print in on UM2 unless you change your firmware to remove the 260C heater limit
Or the UMO due to the potential of melting the plastic parts in the hotend.
True, I would use an UMO with E3D hotend (WHICH I STILL HAVEN'T INSTALLED, DAMMIT!!!!!)
Recommended Posts
jonnybischof 60
Sounds interesting, do you know where to get it?
/edit: ok, E3D sells it. Quite expensive - around the price range of top-line PLA filaments (Diamond Age, Faberdashery).
I'd be most interested in a comparison to XT as this sounds to be a direct competitor...
Link to post
Share on other sites