UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
eventuell hätte ich einen Käufer. Warum verkaufst du den Drucker? Wann wurde er gekauft? Wie viele Betriebsstunden etwa? Welche Materialien wurden gedruckt? Welche Filament Rollen sind dabei? Irgendwelche anstehenden Wartungsarbeiten? Kannst du ein Bild vom Hot-End machen? Wo steht das Gerät?
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
3d4you 0
Hallo,
eventuell hätte ich einen Käufer. Warum verkaufst du den Drucker? Wann wurde er gekauft? Wie viele Betriebsstunden etwa? Welche Materialien wurden gedruckt? Welche Filament Rollen sind dabei? Irgendwelche anstehenden Wartungsarbeiten? Kannst du ein Bild vom Hot-End machen? Wo steht das Gerät?
Gruß,
Matthias
Link to post
Share on other sites