Jump to content
Ultimaker Community of 3D Printing Experts

The worse pla?


Recommended Posts

Posted · The worse pla?

I mean... I want to double extrude pla materials using other pla as support but I was wondering (since this it's just an idea and prolly a bad one) if anyone knows some kind of pla that might have zero warping (or close), bad adhesion (so it can be easyer to break it) and if posible that could be britle (to break it easyer). I don't want to go the hips/pva road since both have chemicals or they can get bad jams etc.

So... What's the worse pla you ever tryed? :)

  • Link to post
    Share on other sites
    Posted · The worse pla?

    I have a lot of complaints regarding E-sun filaments (never tried it tough), mainly because it's 3mm and not 2.85mm i think so maybe not a good choice.

    And i'm not sure it would help to create supports in one pla and the model in another one, i don't see any advantage between that and printing the whole model with support in single extrusion... it will probably be less of a headache i think

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...