Jump to content

Jumper to shut down USB power


Recommended Posts

Posted · Jumper to shut down USB power

Hi!

I read that there is a jumper in the PCB that, when open, disconnects the USB power. I want that the Ultimaker shuts down when the power switch is turned off, but I dont know which one of the jumpers it is.

Thanks!

  • Link to post
    Share on other sites

    Posted · Jumper to shut down USB power

    @anon: thank you ;) it's an UMO! Are you sure about it? According to http://wiki.ultimaker.com/Electronics_build_guide there is one, somewhere...

    "Starting from the 1.5.6 electronics, the electronics can be powered stand-alone. This may cause the fan and other electronics to run from your USB port. If you don't want this, you can 'open' the following jumper:"

    @avi: i also thought about that way, but i would prefer another solution :)

  • Link to post
    Share on other sites

    Posted · Jumper to shut down USB power

    I think that page is incorrect. As far as I know, USB power goes directly to the Arduino's USB port. If there is a jumper to disconnect it, it would be on the Arduino. As far as I know, there is no such jumper on the Arduino.

     

  • Link to post
    Share on other sites

    Posted · Jumper to shut down USB power

    Hmmm, very interesting. I checked the Mega's schematic and board files and there is a bridge that can be cut that disconnects the USB GND from the power GND.

    This MAY, REPEAT MAY prevent the Mega from running on USB power. CUT THIS AT YOUR OWN RISK.

    I think the worse case is that USB comm stops working but you should be able to reverse it with a blob of solder.

    ArduinoMega2560 R3 Back

     

    • Like 1
    Link to post
    Share on other sites

    Posted (edited) · Jumper to shut down USB power

    I think they meant the ARD_PWR jumper, but if you remove it the whole arduino board is no longer supplied with voltage from the power supply. You cannot print without the USB cable connected then?!

    Anyway, I found another solution here (where you also replied). I guess i found a more elegant solution to this problem:

    https://ultimaker.com/en/community/view/6131-disabling-usb-power-because-my-memory-is-crap

    Edited by Guest
  • Link to post
    Share on other sites

    Posted · Jumper to shut down USB power

     

    @anon4321: I tried what you suggested but since UGND and GND are connected internally (in the ATMEL) GND is still available on the board. I will desolder the MOSFET FDN340P ;)

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...