Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  
bryanzd

Print bed moves down once print is started...

Recommended Posts

Alright, all other problems encountered so far have been solved thanks to this forum, hopefully this will be the last one.

When a print is initiated, the print bed moves down about 10cm and the machine prints into open air.

All movements are silky smooth, extruder is working, print head is dispensing, heated parts work great, but what could be wrong with the z axis?

 

Share this post


Link to post
Share on other sites

The Z axis move should show up in the g code as a line starting with G0 or G1 and then Znnn where nnn should be a value like 100 in your case as this is the distance in mm of the move. So something like G0 Z100 would indikate that the slicer for some reason inserts the move. If you do not find something like that, then it should be a problem in the firmware or hardware somewhere. If you find it, then it is a software or parameters issue I would think.

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!